EVOLV Error Codes

ERROR CODE

Fault Code

Diagnostic Step

Resolution

0

Normal Status

Normally ok; Turn off and on scooter to see if the error persists

Normally ok

2

Brake

Check brake lever on handlebar and see if brake springs all the way back;

Give the brake lever a few hard presses to ensure that it is not stuck; if jammed, unclog the source of the jam

Check brake caliper to see if the brake line is springing back to original position. Also check brake hose to see if it is jammed.

If brake caliper is not springing back, spray some wd40 to make sure it springs back to original position.

6

Battery Undervoltage

Check LCD setting P03 and P15; Give battery a full charge to see if the issue persists

P03 should be in accordance with the voltage specified in the user manual. P15 should be the specified voltage – 6V

7

Motor Fault

Unplug and plug motor connector back in to see if issue persists;

If problem is resolved, then make sure connecter is pushed in all the way.

If issue persists; check motor wire and connector pins see if there are any issues.

Either replace the motor or replace the motor wire.

8

Turnstile Fault

Check if back screw or magnet has come loose in the throttle/LCD

Tighten back screw or replace magnet in throttle

9

Controller Fault

Replace controller

Replace controller

10

Communication Receiving Fault

Unplug and plug in LCD connector and see if issue persists; If issue persists, wiggle the LCD wire in different directions to see if problem persists

Change of wiring hardness from LCD to controller might be needed if the issue persists

11

Communication Transmission Fault

Unplug and plug in controller connector and see if issue persists; If issue persists wiggle the LCD wire in different directions to see if problem persists

Change of wiring hardness from LCD to controller might be needed if the issue persists

12

BMS comm Failure

Check if battery is able to charge; if battery is able to charge, then check connector of battery to controller;

If problem persists, then a battery change might be necessary